Removing and Installing the Fan
Workstation Setup & Administration Guide • 37
?
6. Lift the fan from the system.
To install the fan
1. Place the two fan tabs, located at the rear of the fan, into the lowest holes
of the rear airflow grate.
2. Gently lower the fan portion onto the board set.
3. Plug the power connector into one of the available internal disk drive
power connectors in the system.
4. Replace the side cover.
Fan plug
Tab s
The side cover is the support for the fan. If you install the fan and
attempt to stand the system up without the side cover on, the fan
will fall out.
Comments to this Manuals