Merging DUA II User Manual download pdf (Page 22)

- 22 -

10 Typical Audio Connections between DUA II & Mykerinos

This section will display some typical audio connection scenarios for DUA II and Mykerinos.

10.1 Audio for Video with SONY Digital BetaCam Users

This example is based on Video NLE & DAW users who are using the Mykerinos in conjunction with a DUA II audio

interface and a Digital BetaCam video deck.

IDEO

& D

IGITAL

UDIO

ORKSTATION

This example shows the following connections:

• The Digital BetaCam outputs are routed through the AES/EBU inputs of the DUA II to the Mykerinos input channels 1-

4 (ADAT).

• The Mykerinos output channels 1-4 (ADAT) are routed through the AES/EBU outputs of the DUA II to the Digital

BetaCam inputs.

• The Mykerinos output channels 1-4 (ADAT) are routed through the analog outputs of the DUA II to the monitoring

system.

(Alternate monitoring is provided by the front panel monitoring selection of the DUA II or the stereo monitoring of the

Mykerinos board).

• The Mykerinos card (via VIDEO/TC bracket or the breakout cable - CVS1IN Input) and the Video Deck are connected

to the Video Ref. generator.

Note that each device should be connected to the video generator with its own cable.

Using the Loop-Through to connect the different devices is not recommended.

• The DUA II is set to ODI sync mode and AutoDetect SR mode.

• The DIP switches 1-8 must be set to: X – X – X – X – OFF – OFF – OFF – OFF.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28 29 30

No comments

Merging DUA II User Manual Page 22